Command Line Reference Guide

542 | Interfaces
www.dell.com | support.dell.com
• portmode hybrid
• rate-interval
• show config
• show config (from INTERFACE RANGE mode)
• show interfaces
• show interfaces configured
• show interfaces dampening
• show interfaces description
• show interfaces linecard
• show interfaces phy
• show interfaces stack-unit
• show interfaces status
• show interfaces switchport
• show interfaces transceiver
• show range
• shutdown
• speed (for 10/100/1000 interfaces)
• speed (Management interface)
• switchport
• wanport
clear counters
c e s
Clear the counters used in the show interfaces commands for all VRRP groups, VLANs, and physical
interfaces or selected ones.
Syntax
clear counters [interface] [vrrp [{[ipv6] vrid | vrf instance}] | learning-limit]
Parameters
interface
(OPTIONAL) Enter any of the following keywords and slot/port or number to clear counters
from a specified interface:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the
slot/port information.
• For a Loopback interface, enter the keyword
loopback followed by a number from 0 to
16383.
• For a Port Channel interface, enter the keyword
port-channel followed by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For the management interface on the RPM, enter the keyword
ManagementEthernet
followed by slot/port information. The slot range is 0-1, and the port range is 0.
• For a SONET interface, enter the keyword
sonet followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed
by the slot/port information.
• For a VLAN, enter the keyword
vlan followed by a number from 1 to 4094.
vrrp
[[ipv6] vrid]
(OPTIONAL) Enter the keyword vrrp to clear the counters of all VRRP groups. To clear the
counters of VRRP groups on all IPv6 interfaces, enter
ipv6. To clear the counters of a
specified group, enter a
vrid number from 1 to 255.