Command Line Reference Guide

GARP VLAN Registration (GVRP) | 507
Command
History
Related
Commands
debug gvrp
c e s
Enable debugging on GVRP.
Syntax
debug gvrp {config | events | pdu}
To disable debugging, use the no debug gvrp {config | events | pdu} command.
Parameters
Defaults
Disabled
Command Modes
EXEC Privilege
Command
History
disable
c e s
Globally disable GVRP.
Syntax
disable
To re-enable GVRP, use the no disable command.
Defaults
Enabled
Command Modes
CONFIGURATION-GVRP
Command
History
Related
Commands
Version 7.6.1.0 Introduced on C, E, and S-Series
show gvrp statistics Display the GVRP statistics
config Enter the keyword config to enable debugging on the GVRP configuration.
event
Enter the keyword event to enable debugging on the JOIN/LEAVE events.
pdu Enter the keyword pdu followed one of the following Interface keywords and slot/port or number
information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the slot/port
information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/
port information.
• For a Port Channel interface, enter the keyword port-channel followed by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the
slot/port information.
Version 7.6.1.0 Introduced on C, E, and S-Series
Version 7.6.1.0 Introduced on C, E, and S-Series
gvrp enable Enable GVRP on physical interfaces and LAGs.
protocol gvrp Access GVRP protocol