Command Line Reference Guide

498 | Force10 Service Agent
www.dell.com | support.dell.com
Command Mode
CONFIGURATION (conf-callhome)
Command
History
Usage
Information
The switch only plays the part of an SMTP client to send email messages to the SMTP server
designated here. This SMTP server is required in order to receive the email messages and forward
them to local and remote designated recipients. The default port number on an SMTP server is 25. If a
host name is given (instead of an IP address), DNS should be enabled to resolve the host name.
Related
Commands
test-condition (comparing samples)
c e
Configure an action to collect and compare multiple samples of a statistic.
Syntax
test-condition statistic operator sample {cpu | rpm-any} number
Parameters
Defaults
None
Version 7.6.1.0 Introduced on C-Series
Version 6.3.1.0 Introduced for E-Series
admin-email Specify the Administrator’s email address.
enable Enable FTSA email messages for the selected recipient.
enable-all Enable FTSA email messages for all designated recipients.
test-condition statistic Enter the keyword test-condition, followed by one of the following statistic
request types:
•
cpu-1-min: Average CPU utilization for 1 minute
•
cpu-5-min: Average CPU utilization for 5 minutes
•
interface-bit-rate {input | output} slot#: Instantaneous bit rate on a
given line card
•
interface-crc interface: Number of CRC errors on a given interface
•
interface-rate {input | output} interface: Packet rate on a given
interface
•
interface-throttles interface: Number of throttles on an interface
•
memory-free: Free system memory
•
memory-free-percent: Free system memory free in percentage
•
memory-used: System memory used
•
memory-used-percent: System memory used in percentage
•
wred-drops interface: Number of WRED drops on an interface
(E-Series only)
operator Enter one of the following Boolean comparison operators: decrease,
equal-to, greater-than, increase, less-than, not-equal-to,
no-change
.
sample number Enter the keyword sample, followed by an integer representing the number
of the sample collected. For example, 5 is the fifth sample collected, so the
first and fifth samples would be compared, using the designated operator.
Range: 2–100
Default: 2
cpu | rpm-any
Enter the processor that will be tested: cp, lp, rp1, rp2, or test all RPM CPUs
with the keyword
rpm-any.