Command Line Reference Guide

Force10 Service Agent | 477
admin-email
c e
Enter the Administrator email address (the address from which FTSA emails are addressed).
Syntax
admin-email email_address
To remove the Administrator’s email address, use the no admin-email command.
Parameters
Defaults
No default behavior or values
Command Modes
CONFIGURATION (conf-callhome)
Command
History
Usage
Information
The domain name part of the email address can be specified here or by using the command
domain-name. In either case, if you specify a domain name by using the domain-name command,
that name will be used for the email address instead of a domain name that you might enter here.
Related
Commands
call-home
c e
This command has two functions:
•Start FTSA.
• Enter the CONFIGURATION (conf-callhome) mode.
Syntax
call-home
To stop FTSA, use the no call-home command. Stopping FTSA removes all FTSA configuration from
the running configuration.
Defaults
No default behavior or values
Command Modes
CONFIGURATION (conf-callhome)
Command
History
email address
You have two choices:
• Enter the administrator’s full email address, for example,
admin@domain_name.com.
• Enter just the username component, for example, admin.
Version 7.6.1.0 Introduced for C-Series
Version 6.3.1.0 Introduced for E-Series
call-home Start FTSA and Enter the FTSA mode.
domain-name Specify the domain name to be used for the Administrator’s email address.
server Configure a recipient.
smtp server-address Identify the local SMTP (Simple Mail Transfer Protocol) server from which FTSA
email messages will be forwarded.
Version 7.6.1.0 Introduced on C-Series
Version 6.3.1.0 Introduced for E-Series