Command Line Reference Guide

472 | Force10 Resilient Ring Protocol (FRRP)
www.dell.com | support.dell.com
Defaults
No default values or behavior
Command Modes
CONFIGURATION
Command
History
Usage
Information
This command places you into the Resilient Ring Protocol. After executing this command, the
command line prompt changes to conf-frrp.
show frrp
c e
Display the Resilient Ring Protocol configuration.
Syntax
show frrp [ring-id [summary]] | [summary]
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
Command
History
Example 1
(summary)
FTOS#show frrp summary
Ring-ID State Mode Ctrl_Vlan Member_Vlans
--------------------------------------------------------------
2 UP Master 2 11-20, 25,27-30
31 UP Transit 31 40-41
50 Down Transit 50 32
FTOS#
Example 2
(ring-id)
FTOS#show frrp 1
Ring protocol 1 is in Master mode
Ring Protocol Interface:
Primary : GigabitEthernet 0/16 State: Forwarding
Secondary: Port-channel 100 State: Blocking
Control Vlan: 1
Ring protocol Timers: Hello-Interval 50 msec Dead-Interval 150 msec
Ring Master's MAC Address is 00:01:e8:13:a3:19
Topology Change Statistics: Tx:110 Rx:45
Hello Statistics: Tx:13028 Rx:12348
Number of state Changes: 34
Member Vlans: 1000-1009
FTOS#
Version 8.2.1.0 Introduced for the C-Series
Version 7.4.1.0 Introduced
ring-id
Enter the ring identification number.
Range: 1 to 255
summary (OPTIONAL) Enter the keyword summary to view just a summarized
version of the Ring configuration.
Version 8.2.1.0 Introduced for the C-Series
Version 7.4.1.0 Introduced