Command Line Reference Guide

470 | Force10 Resilient Ring Protocol (FRRP)
www.dell.com | support.dell.com
interface
c e
Configure the primary, secondary, and control-vlan interfaces.
Syntax
interface {primary interface secondary interface control-vlan vlan-id}
To return to the default, use the no interface {primary interface secondary interface control-vlan
vlan-id} command.
Parameters
Defaults
No default values or behavior
Command Modes
CONFIGURATION (conf-frrp)
Command
History
Usage
Information
This command causes the Ring Manager to take ownership of these two ports after the configuration is
validated by the IFM. Ownership is relinquished for a port only when the interface does not play a part
in any control VLAN, that is, the interface does not belong to any ring.
Related
Commands
primary interface
Enter the keyword primary to configure the primary interface followed by one of
the following interfaces and slot/port information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by the
slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
secondary interface
Enter the keyword secondary to configure the secondary interface followed by one
of the following interfaces and slot/port information:
• For a Fast Ethernet interface, enter the keyword FastEthernet followed by the
slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
control-vlan vlan-id
Enter the keyword control-vlan followed by the VLAN ID.
Range: 1 to 4094
Version 8.2.1.0 Introduced for the C-Series
Version 7.4.1.0 Introduced
show frrp Display the Resilient Ring Protocol configuration information