Command Line Reference Guide

Far-End Failure Detection (FEFD) | 465
Example FTOS#sh fefd
FEFD is globally 'ON', interval is 10 seconds, mode is 'Aggressive'.
INTERFACE MODE INTERVAL STATE
(second)
Gi 5/0 Aggressive 10 Admin Shutdown
Gi 5/1 Aggressive 10 Admin Shutdown
Gi 5/2 Aggressive 10 Admin Shutdown
Gi 5/3 Aggressive 10 Admin Shutdown
Gi 5/4 Aggressive 10 Admin Shutdown
Gi 5/5 Aggressive 10 Admin Shutdown
Gi 5/6 Aggressive 10 Admin Shutdown
Gi 5/7 Aggressive 10 Admin Shutdown
Gi 5/8 Aggressive 10 Admin Shutdown
Gi 5/9 Aggressive 10 Admin Shutdown
Gi 5/10 NA NA Locally disabled
Gi 5/11 Aggressive 10 Err-disabled
FTOS#
Table 19-37. Description of show fefd display
Field Description
Interface Displays the interfaces type and number.
Mode Displays the mode (aggressive or normal) or NA if the interface contains fefd disable in
its configuration.
Interval Displays the interval between FEFD packets.
State Displays the state of the interface and can be one of the following:
• bi-directional (interface is up and connected and seeing neighbor’s echoes)
• err-disabled (only found when the FEFD mode is aggressive and when the interface
has not seen its neighbor’s echoes for 3 times the message interval. To reset an
interface in this state, use the fefd reset command.)
• unknown (only found when FEFD mode is normal
• locally disabled (interface contains the fefd disable command in its configuration)
• Admin Shutdown (interface is disabled with the shutdown command)