Command Line Reference Guide

410 | Content Addressable Memory (CAM) for ExaScale
www.dell.com | support.dell.com
cam-profile template [10M-CAM]
e
x
Select a pre-defined CAM-profile template or create a new CAM-profile template.
Syntax
cam-profile template {10M-CAM}
Parameters
Defaults
Default
Command Modes
CONFIGURATION
Command
History
Usage
Information
CAM profile changes take effect after the next chassis reboot.
CAM-profile template region allocations are not automatically configured when you select a template.
Us e the allocations shown in the Content Addressable Memory for ExaScale chapter in the FTOS
Configuration Guide for detailed values supported in each CAM/SRAM region.
enable
e
x
Enable CAM-profile template.
Syntax
enable
Defaults
cam-profile default microcode default
Command Modes
CONFIGURATION-CAM-profile-template
Command
History
Usage
Information
You must save the running configuration using the command copy running-config startup-config
after changing the CAM-profile. CAM-profile template changes take effect after the next chassis
reboot.
template
Choose one of the following CAM profiles:
•
10M L2 to support IPv4 Layer 2 switching on line cards with 10M CAM.
•
10M L2 IPv6 Switching to support IPv6 Layer 2 switching on line cards with 10M
CAM.
• 40M L2 IPv6-IPv4 to support IPv4 and IPv6 Layer 2 routing on line cards with
40M CAM.
• 40M L2 IPv4Only to support IPv4 Layer 2 routing on line cards with 40M CAM.
• VRF to support Virtual Routing and Forwarding (VRF).
• MAX-IPv4-FIB to allocate the maximum space supported for IPv4 FIB support.
• Enter a 16 character string used as a template name to create a new template.
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 8.2.1.0 Introduced on E-Series ExaScale