Command Line Reference Guide

396 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
Related
Commands
show ip bgp peer-group
c e
t
s
Enables you to view information on the BGP peers in a peer group.
Syntax
show ip bgp ipv4 multicast peer-group [peer-group-name [detail | summary]]
Parameters
Command Modes
EXEC
EXEC Privilege
Related
Commands
Command
History
(List of inbound and
outbound policies)
Displays the policy commands configured and the names of the Route map,
AS-PATH ACL or Prefix list configured for the policy.
For address family: Displays IPv4 Multicast as the address family.
BGP table version Displays the which version of the primary BGP routing table the router and the
neighbor are using.
Prefixes accepted Displays the number of network prefixes accepted by the router and the amount of
memory used to process those prefixes.
Prefixes advertised Displays the number of network prefixes advertised, the number rejected and the
number withdrawn from the BGP routing table.
Connections established Displays the number of TCP connections established and dropped between the two
peers to exchange BGP information.
Last reset Displays the amount of time since the peering session was last reset. Also states if
the peer resets the peering session.
If the peering session was never reset, the word never is displayed.
Local host: Displays the peering address of the local router and the TCP port number.
Foreign host: Displays the peering address of the neighbor and the TCP port number.
Table 13-32. Command Example fields: show ip bgp ipv4 multicast neighbors
Lines beginning with Description
show ip bgp View the current BGP routing table.
peer-group-name
(OPTIONAL) Enter the name of a peer group to view information about that peer
group only.
detail (OPTIONAL) Enter the keyword detail to view detailed status information of the
peers in that peer group.
summary (OPTIONAL) Enter the keyword summary to view status information of the
peers in that peer group.
The output is the same as that found in show ip bgp summary command
neighbor peer-group (assigning peers) Assign peer to a peer-group.
neighbor peer-group (creating group) Create a peer group.
show ip bgp peer-group View information on the BGP peers in a peer group.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series