Command Line Reference Guide

394 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
Command Modes
EXEC
EXEC Privilege
Command
History
Example FTOS#show ip bgp ipv4 multicast neighbors
BGP neighbor is 25.25.25.25, remote AS 6400, internal link
BGP version 4, remote router ID 25.25.25.25
BGP state ESTABLISHED, in this state for 00:02:18
Last read 00:00:16, hold time is 180, keepalive interval is 60 seconds
Received 1404 messages, 0 in queue
3 opens, 1 notifications, 1394 updates
6 keepalives, 0 route refresh requests
Sent 48 messages, 0 in queue
3 opens, 2 notifications, 0 updates
43 keepalives, 0 route refresh requests
Minimum time between advertisement runs is 5 seconds
Minimum time before advertisements start is 0 seconds
Capabilities received from neighbor for IPv4 unicast :
MULTIPROTO_EXT(1)
ROUTE_REFRESH(2)
CISCO_ROUTE_REFRESH(128)
Capabilities advertised to neighbor for IPv4 Multicast :
MULTIPROTO_EXT(1)
ROUTE_REFRESH(2)
CISCO_ROUTE_REFRESH(128)
Update source set to Loopback 0
For address family: IPv4 Multicast
BGP table version 14, neighbor version 14
3 accepted prefixes consume 12 bytes
Prefixes accepted 1 (consume 4 bytes), withdrawn 0 by peer
Prefixes advertised 0, rejected 0, withdrawn 0 from peer
Connections established 2; dropped 1
Last reset 00:03:17, due to user reset
received-routes
[network
[
network-mask]
(OPTIONAL) Enter the keywords received-routes followed by either the
network address (in dotted decimal format) or the network mask (in slash prefix
format) to view all information received from neighbors.
Note: neighbor soft-reconfiguration inbound must be configured prior to viewing
all the information received from the neighbors.
denied-routes [network
[
network-mask]
(OPTIONAL) Enter the keywords denied-routes followed by either the network
address (in dotted decimal format) or the network mask (in slash prefix format) to
view all information on routes denied via neighbor inbound filters.
Version 8.4.1.0 Added support for the display of configured IPv4 multicast address families
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.5.1.0
Added
detail option and output now displays default MED value
Version 7.2.1.0 Added received and denied route options
Version 6.3.10 The output is changed to display the total number of advertised prefixes