Command Line Reference Guide

378 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
Defaults
Disabled
Command Modes
EXEC Privilege
Usage
Information
This command turns on BGP soft-reconfiguration inbound debugging for IPv4 multicast routes. If no
neighbor is specified, debug is turned on for all neighbors.
Command
History
debug ip bgp peer-group updates
c e
t
s
View information about BGP peer-group updates.
debug ip bgp peer-group peer-group-name updates [in | out]
To disable debugging, enter no debug ip bgp peer-group peer-group-name updates [in | out]
command.
Parameters
Command Modes
EXEC Privilege
Command
History
debug ip bgp updates
c e
t
s
View information about BGP updates.
debug ip bgp updates [in | out]
To disable debugging, enter no debug ip bgp updates [in | out] command.
Parameters
Version 8.4.1.0 Introduced support for IPv4 multicast and IPv6 unicast routes
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.2.1.0 Introduced
peer-group
peer-group-name
Enter the keyword peer-group followed by the name of the peer-group.
updates Enter the keyword updates to view BGP update information.
in (OPTIONAL) Enter the keyword in to view only BGP updates received from
neighbors.
out (OPTIONAL) Enter the keyword out to view only BGP updates sent to
neighbors.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.6.1.0 Introduced IPv6 MGBP support for E-Series
updates Enter the keyword updates to view BGP update information.
in (OPTIONAL) Enter the keyword in to view only BGP updates received from neighbors.
out (OPTIONAL) Enter the keyword out to view only BGP updates sent to neighbors.