Command Line Reference Guide

Border Gateway Protocol IPv4 (BGPv4) | 371
show running-config bgp
c e s
Use this feature to display the current BGP configuration.
Syntax
show running-config bgp
Defaults
No default values or behavior
Command Modes
EXEC Privilege
Command
History
timers bgp
c e s
Adjust BGP Keep Alive and Hold Time timers.
Syntax
timers bgp keepalive holdtime
To return to the default, enter no timers bgp.
Parameters
Defaults
No default values or behavior
Command Modes
ROUTER BGP
Command
History
MBGP Commands
Multiprotocol BGP (MBGP) is an enhanced BGP that enables multicast routing policy throughout the
Internet and connecting multicast topologies between BGP and autonomous systems (AS). FTOS
MBGP is implemented as per IETF RFC 1858.
FTOS version 7.8.1.0 and later support MBGP for IPv6 on
e
t
and c platforms.
FTOS version 7.8.1.0 and later supports MBGP for IPv4 Multicast only on the
s platform.
Version 7.8.1.0 Introduced on S-Series
Version 7.7.1.0 Introduced on C-Series
Version 7.6.1.0 Introduced on E-Series
keepalive
Enter a number for the time interval, in seconds, between keepalive messages sent
to the neighbor routers.
Range: 1 to 65535
Default: 60 seconds
holdtime
Enter a number for the time interval, in seconds, between the last keepalive message
and declaring the router dead.
Range: 3 to 65535
Default: 180 seconds
Version 7.8.1.0 Introduced on S-Series
Version 7.7.1.0 Introduced on C-Series
Version 7.6.1.0 Introduced on E-Series