Command Line Reference Guide

340 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
Defaults
Not configured.
Command Modes
ROUTER BGP
Usage
Information
FTOS software resolves the network address configured by the network command with the routes in
the main routing table to ensure that the networks are reachable via non-BGP routes and non-default
routes.
Related
Commands
Command
History
network backdoor
c e s
Specify this IGP route as the preferred route.
Syntax
network ip-address mask backdoor
To remove a network, use the no network ip-address mask backdoor command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP
Usage
Information
Though FTOS does not generate a route due to backdoor config, there is an option for injecting/
sourcing a local route in presence of network backdoor config on a learned route.
Command
History
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the name of an established route
map.
Only the following ROUTE-MAP mode commands are supported:
• match ip address
• set community
• set local-preference
• set metric
• set next-hop
• set origin
• set weight
If the route map is not configured, the default is deny (to drop all routes).
redistribute Redistribute routes into BGP.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
ip-address
Enter an IP address in dotted decimal format of the network.
mask
Enter the mask of the IP address in the slash prefix length format (for example, /24).
The mask appears in command outputs in dotted decimal format (A.B.C.D).
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series