Command Line Reference Guide

34 | File Management
www.dell.com | support.dell.com
cd
c e s
Change to a different working directory.
Syntax
cd directory
Parameters
Command Modes
EXEC Privilege
Command
History
change bootflash-image
c e
Change boot flash image from which to boot.
Syntax
change bootflash-image {cp | linecard linecard-slot | rp}
Parameters
Defaults
Not configured.
Command Modes
EXEC Privilege
Command
History
Usage
Information
A system message appears stating that the bootflash image has been changed. You must reload the
system before the system can switch to the new bootflash image.
directory
(OPTONAL) Enter one of the following:
•
flash: (internal Flash) or any sub-directory
•
slot0: (external Flash) or any sub-directory (C-Series and E-Series only)
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
cp Enter the keyword cp to change the bootflash image on the Control Processor
on the RPM.
linecard linecard-slot Enter the keyword linecard followed by the slot number to change the
bootflash image on a specific line card.
C-Series Range: 0-7
E-Series Range: 0 to 13 on the E1200; 0 on 6 on the E600, and 0 to 5 on the
E300.
rp Enter the keyword rp to change the bootflash image on the RPM Route
Processor.
Version 7.5.1.0 Introduced on C-Series
E-Series original Command