Command Line Reference Guide

324 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
Command Modes
ROUTER BGP
Usage
Information
If you apply a route map to a BGP peer or neighbor with the neighbor default-originate command
configured, the software does not apply the set filters in the route map to that BGP peer or neighbor.
Command
History
neighbor description
c e s
Assign a character string describing the neighbor or group of neighbors (peer group).
Syntax
neighbor {ip-address | peer-group-name} description text
To delete a description, use the no neighbor {ip-address | peer-group-name} description
command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP
Command
History
neighbor distribute-list
c e s
Distribute BGP information via an established prefix list.
Syntax
neighbor {ip-address | peer-group-name} distribute-list prefix-list-name {in | out}
To delete a neighbor distribution list, use the no neighbor {ip-address | peer-group-name}
distribute-list prefix-list-name {in | out} command.
Parameters
Defaults
Not configured.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
ip-address
Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
Enter the name of the peer group.
text
Enter a continuous text string up to 80 characters.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
ip-address
Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
Enter the name of the peer group to apply the distribute list filter to all routers in
the peer group.
prefix-list-name
Enter the name of an established prefix list.
If the prefix list is not configured, the default is permit (to allow all routes).
in Enter the keyword in to distribute only inbound traffic.
out Enter the keyword out to distribute only outbound traffic.