Command Line Reference Guide

318 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
debug ip bgp updates
c e s
Enables you to view information about BGP updates.
Syntax
debug ip bgp updates [in | out | prefix-list prefix-list-name]
To disable debugging, use the no debug ip bgp [ip-address | peer-group peer-group-name]
updates [in | out] command.
Parameters
Command Modes
EXEC Privilege
Usage
Information
Enter no debug ip bgp command to remove all configured debug commands for BGP.
Command
History
default-metric
c e s
Enables you to change the metrics of redistributed routes to locally originated routes. Use this
command with the redistribute command.
Syntax
default-metric number
To return to the default setting, enter no default-metric.
Parameters
Defaults
0
Command Modes
ROUTER BGP
Usage
Information
The default-metric command in BGP sets the value of the BGP MULTI_EXIT_DISC (MED) attribute
for redistributed routes only.
Version 7.7.1.0 Introduced support on C-Series
Version 7.2.1.0 Introduced
in (OPTIONAL) Enter the keyword in to view only BGP updates received from neighbors.
out (OPTIONAL) Enter the keyword out to view only BGP updates sent to neighbors.
prefix-list
prefix-list-name
(OPTIONAL) Enter the keyword prefix-list followed by the name of an established
prefix list. If the prefix list is not configured, the default is permit (to allow all routes).
ip-address
(OPTIONAL) Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
(OPTIONAL) Enter the name of the peer group to disable or enable all routers within the
peer group.
Version 7.7.1 Introduced support on C-Series
number
Enter a number as the metric to be assigned to routes from other protocols.
Range: 1 to 4294967295.