Command Line Reference Guide

282 | Bidirectional Forwarding Detection (BFD)
www.dell.com | support.dell.com
Command
History
bfd enable (Configuration)
c e
Enable BFD on all interfaces.
Syntax
bfd enable
Disable BFD using the no bfd enable command.
Defaults
BFD is disabled by default.
Command Modes
CONFIGURATION
Command
History
bfd enable (Interface)
c e
Enable BFD on an interface.
Syntax
bfd enable
Defaults
BFD is enabled on all interfaces when you enable BFD from CONFIGURATION mode.
Command Modes
INTERFACE
Command
History
bfd interval
c e
Specify non-default BFD session parameters beginning with the transmission interval.
Syntax
bfd interval interval min_rx min_rx multiplier value role {active | passive}
Parameters
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on C-Series
Version 7.5.1.0 Introduced on E-Series
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series
interval milliseconds
Enter this keyword to specify non-default BFD session parameters beginning
with the transmission interval.
Range:50-1000
Default:100