Command Line Reference Guide

CLI Basics | 25
IP COMMUNITY LIST Mode
Use the IP COMMUNITY LIST mode to configure an IP Community ACL on the E-Series. Refer to
Chapter 10, Access Control Lists (ACL).
To enter IP COMMUNITY LIST mode:
1. Verify that you are logged in to the CONFIGURATION mode.
2. Enter the ip community-list command. You must include a name for the Community list.The
prompt changes to include (config-community-list).
You can return to the CONFIGURATION mode by entering the exit command.
REDIRECT-LIST Mode
Use the REDIRECT-LIST mode to configure a Redirect list on the E-Series, as described in
Chapter 41, Policy-based Routing (PBR).
To enter REDIRECT-LIST mode:
1. Verify that you are logged in to the CONFIGURATION mode.
2. Use the ip redirect-list command. You must include a name for the Redirect-list.The prompt
changes to include (conf-redirect-list).
You can return to the CONFIGURATION mode by entering the exit command.
SPANNING TREE Mode
Use the STP mode to enable and configure the Spanning Tree protocol, as described in Chapter 60,
Spanning Tree Protocol (STP).
To enter STP mode:
1. Verify that you are logged into the CONFIGURATION mode.
2. Enter the protocol spanning-tree stp-id command.
You can return to the CONFIGURATION mode by entering the exit command.
Per-VLAN SPANNING TREE Plus Mode
Use PVST+ mode to enable and configure the Per-VLAN Spanning Tree (PVST+) protocol, as
described in Chapter 48, Per-VLAN Spanning Tree plus (PVST+).
To enter PVST+ mode:
1. Verify that you are logged into the CONFIGURATION mode.
2. Enter the protocol spanning-tree pvst command.
You can return to the CONFIGURATION mode by entering the exit command.
Note: The protocol is PVST+, but the plus sign is dropped at the CLI prompt