Command Line Reference Guide

244 | Access Control Lists (ACL)
www.dell.com | support.dell.com
Command
History
Usage
Information
Sequence numbers for this filter are automatically assigned starting at sequence number 5.
If the options ge or le are not used, only packets with an exact match to the prefix are filtered.
Related
Commands
ip prefix-list
c e s
Enter the PREFIX-LIST mode and configure a prefix list.
Syntax
ip prefix-list prefix-name
Parameters
Command Modes
CONFIGURATION
Command
History
Usage
Information
Prefix lists redistribute OSPF and RIP routes meeting specific criteria. For related RIP commands
supported on C-Series and E-Series, see Chapter 50, Router Information Protocol (RIP). For related
OSPF commands supported on all three platforms, see Chapter 40, Open Shortest Path First (OSPFv2
and OSPFv3).
Prior to 7.8.1.0, names are up to 16 characters long.
Related
Commands
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
permit Configure a filter to pass packets.
seq Configure a drop or permit filter with a specified sequence number.
prefix-name
Enter a string up to 16 characters long as the name of the prefix list, up to 140 characters
long.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to
16 characters long.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
show ip route list Display IP routes in an IP prefix list.
show ip prefix-list summary Display a summary of the configured prefix lists.