Command Line Reference Guide

236 | Access Control Lists (ACL)
www.dell.com | support.dell.com
Defaults
Not configured.
Command Modes
CONFIGURATION-MAC ACCESS LIST-STANDARD
Command
History
Usage
Information
When you use the log option, CP processor logs details about the packets that match. Depending on
how many packets match the log entry and at what rate, the CP may become busy as it has to log these
packets’ details.
Related
Commands
seq
c e s
Assign a sequence number to a deny or permit filter in a MAC access list while creating the filter.
Syntax
seq sequence-number {deny | permit} {any | mac-source-address
[mac-source-address-mask]} [count [byte]] [log] [monitor]
Parameters
log (OPTIONAL, E-Series only) Enter the keyword log to log the packets.
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic
that you want to monitor and the ACL in which you are creating the rule will be
applied to the monitored interface. For details, see the section “Flow-based
Monitoring” in the Port Monitoring chapter of the FTOS Configuration Guide.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
Note: When ACL logging and byte counters are configured simultaneously, byte counters may display
an incorrect value. Configure packet counters with logging instead.
deny Configure a MAC ACL filter to drop packets.
seq Configure a MAC ACL filter with a specified sequence number.
sequence-number
Enter a number between 0 and 65535.
deny Enter the keyword deny to configure a filter to drop packets meeting
this condition.
permit Enter the keyword permit to configure a filter to forward packets
meeting this criteria.
any Enter the keyword any to filter all packets.
mac-source-address
Enter a MAC address in nn:nn:nn:nn:nn:nn format.
mac-source-address-mask
(OPTIONAL) Specify which bits in the MAC address must match. If
no mask is specified, a mask of 00:00:00:00:00:00 is applied (in other
words, the filter allows only MAC addresses that match).
count (OPTIONAL) Enter the keyword count to count packets processed by
the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed by the
filter.
log (OPTIONAL, E-Series only) Enter the keyword log to log the packets.