Command Line Reference Guide

Access Control Lists (ACL) | 197
The monitor option is relevant in the context of flow-based monitoring only. See Chapter 46, Port
Monitoring.
The C-Series and S-Series cannot count both packets and bytes, so when you enter the count byte
options, only bytes are incremented.
Related
Commands
resequence access-list
c e s
Re-assign sequence numbers to entries of an existing access-list.
Syntax
resequence access-list {ipv4 | ipv6 | mac} {access-list-name StartingSeqNum
Step-to-Increment}
Parameters
Defaults
No default values or behavior
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
When all sequence numbers have been exhausted, this feature permits re-assigning new sequence
number to entries of an existing access-list.
Related
Commands
\
Note: When ACL logging and byte counters are configured simultaneously, byte counters may display
an incorrect value. Configure packet counters with logging instead.
deny Assign a IP ACL filter to deny IP packets.
ip access-list standard Create a standard ACL.
ipv4 | ipv6 | mac Enter the keyword ipv4, or mac to identify the access list type to resequence.
access-list-name
Enter the name of a configured IP access list.
StartingSeqNum
Enter the starting sequence number to resequence.
Range: 1 - 4294967290
Step-to-Increment
Enter the step to increment the sequence number.
Range: 1 - 4294967290
Version 8.2.1.0 Introduced on E-Series ExaScale (IPv6)
Version 8.1.1.0 Introduced on E-Series ExaScale (IPv4)
Version 7.8.1.0 Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names
are up to 16 characters long.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
Version 7.4.1.0 Introduced
resequence prefix-list ipv4 Resequence a prefix list