Command Line Reference Guide

802.1ah | 167
ethernet oam remote-loopback
s
Start or stop loopback operation on a local interface with a remote peer.
Syntax
ethernet oam remote-loopback {start | stop} interface interface
Parameters
Defaults
Enabled
Command Mode
EXEC Privilege
Command
History
ethernet oam remote-loopback (interface)
s
Enable support for OAM loopback on an interface and configure a timeout value.
Syntax
ethernet oam remote-loopback {supported | timeout seconds}
Parameters
Defaults
None
Command Mode
INTERFACE
Command
History
ethernet oam timeout
s
Specify the amount of time that the system waits to receive an OAMPDU from a peer before
considering it non-operational.
Syntax ethernet oam timeout value
Parameters
Defaults
5 seconds
Command Mode
INTERFACE
Command
History
start | stop Start or stop a loopback operation with a remote peer.
interface interface Specify the interface on which remote-loopback starts/stops, for example
gigabitethernet 0/1.
Version 8.4.1.0 Introduced on S-Series
supported Start or stop a loopback operation on a peer.
timeout seconds Specify the number of seconds that the local peer waits to receive a returned frame
before considering a remote peer to be non-operational. Valid values are from 1 to 10.
Version 8.4.1.0 Introduced on S-Series
value Enter a timeout value in seconds.
Range: 2-30 seconds
Version 8.4.1.0 Introduced on S-Series