Command Line Reference Guide

166 | 802.1ah
www.dell.com | support.dell.com
Defaults
As above
Command Mode
INTERFACE
Command
History
ethernet oam mode
s
Set the transmission mode to active or passive.
Syntax ethernet oam mode {active | passive}
Parameters
Defaults
Active
Command Mode
INTERFACE
Command
History
ethernet oam remote-failure
s
Block or disable an interface when a particular critical link event occurs.
Syntax ethernet oam remote-failure {critical-event | dying-gasp | link-fault} action {error-block-interface |
error-disable-interface}
Parameters
Defaults
Disabled
Command Mode
INTERFACE
Command
History
Version 8.4.1.0 Introduced on S-Series
active | passive Choose either active or passive mode for the interface.
Version 8.4.1.0 Introduced on S-Series
critical-event An unspecified critical event occurred.
dying-gasp An unrecoverable local failure condition occurred.
link-fault A fault occurred in the receive direction of the local peer.
error-block-interface Block the interface if the specified fault occurs.
error-disable-interface Disable the interface if the specified fault occurs.
Version 8.4.1.0 Introduced on S-Series