Command Line Reference Guide

Control and Monitoring | 157
util-threshold cpu (S-Series)
s
Configure the high or low CPU utilization thresholds for SNMP traps.
Syntax
util-threshold cpu {5sec | 1min | 5min} {Management-unit | standby | stack-unit unit-number | all}
{high {0-100} | {low [0-100}}}
To return to the default setting, enter no util-threshold cpu.
Parameters
Defaults
High threshold cpu default = 92%
Low threshold cpu default = 82%
Command Modes
CONFIG
Command
History
Usage
Information
When the total CPU utilization exceeds the configured threshold for a given time, a threshold
notification is sent as a SNMP trap. If a low threshold value is not specified, the low threshold value is
set to the same value as the high threshold value. The system will generate a SYSLOG and SNMP Trap
each time the configured threshold is crossed.
Related
Commands
cpu utilization time Enter the keyword that indicates the amount of threshold time to configure the CPU
utilization thresholds.
•5sec
•1min
•5min
unit Indicate the unit where you want to configure the CPU utilization thresholds.
• Management-unit
• standby
• stack-unit unit-number = select the number of the unit in the stack
• all = use all of the units to configure the cpu utilization information.
utilization threshold in % Indicate the high or low values for the CPU utilization threshold in percentage format.
• high. Range: 0 - 100
• low. Range: 0 - 100
Note: A threshold level of 0 will disable the syslog and SNMP trap.
Version 8.4.2.2 Introduced on C-Series, S25 and S50
Version 8.4.2.0 Introduced on E-Series TeraScale
Version 8.4.1.0 Introduced on E-Series ExaScale
show util-threshold cpu Display the set values of the cpu utilization thresholds
show util-threshold mem Display the set values of the memory utilization thresholds