Command Line Reference Guide

Control and Monitoring | 153
terminal xml
c e
Enable XML mode in Telnet and SSH client sessions.
Syntax
terminal xml
To exit the XML mode, enter terminal no xml.
Defaults
Disabled
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
This command enables the XML input mode where you can either cut and paste XML requests or enter
the XML requests line-by-line. For more information on using the XML feature, refer to the XML
chapter in the FTOS Configuration Guide.
traceroute
c e s
View a packet’s path to a specific device.
Syntax
traceroute {host | vrf instance | ip-address | ipv6-address}
Parameters
Defaults
Timeout = 5 seconds; Probe count = 3; 30 hops max; 40 byte packet size; UDP port = 33434
Command Modes
EXEC
EXEC Privilege
Command
History
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.7.1.0 Introduced on C-Series
Version 6.5.1.0 Introduced for E-Series
host
Enter the name of device.
vrf instance (Optional) E-Series Only: Enter the keyword vrf followed by the VRF Instance name.
ip-address
Enter the IP address of the device in dotted decimal format.
ipv6-address Enter the IPv6 address, in the x:x:x:x::x format, to which you are testing connectivity.
Note: The
:: notation specifies successive hexadecimal fields of zeros
Version 8.4.1.0 IPv6 tracerouting available on management interface.
Version 8.2.1.0 Introduced on E-Series ExaScale with IPv6
Version 8.1.1.0 Introduced on E-Series ExaScale (IPv4 only)
Version 7.9.1.0 Introduced VRF.
Version 7.6.1.0 Added support for S-Series
Version 7.5.1.0 Introduced on C-Series
Version 7.4.1.0 Added support for IPv6 address on E-Series
E-Series original Command