Command Line Reference Guide

E-Series Debugging and Diagnostics | 1471
Hardware Commands
These commands display information from a hardware sub-component or ASIC.
The commands in this section are:
• clear hardware btm
• clear hardware rpm mac counters
• hardware monitor linecard
• hardware monitor mac
• hardware watchdog
• show cpu-interface-stats
• show hardware btm
• show hardware fpc forward
• show hardware fpc lookup detail
• show hardware rpm cp
• show hardware rpm mac counters
• show hardware rpm rp1/rp2
• show interfaces link-status
• show logging driverlog
• show running-config hardware-monitor
Refer also to Chapter 25, Interfaces:
• show interfaces phy
• show interfaces transceiver
clear hardware btm
e
Clear the Buffer Traffic Manager (BTM) error counters and status registers.
Syntax
clear hardware {rpm | linecard} number port-set pipe-number btm {egress | ingress | all}
{errors | status}
Parameters
Warning: These commands should be used only when you are working directly with Dell
Force10 TAC (Technical Assistance Center) while troubleshooting a problem. Do not use
these command without the assistance of a Dell Force10 TAC representative. To contact Dell
Force10 TAC for assistance:
E-mail Direct Support: [e-mail]
Web: www.force10networks.com/support/
Telephone support:
US and Canada customers: 866-965-5800
International customers: 408-965-5800
rpm Enter the keyword rpm to clear BTM error counters or status registers on the RPM.
linecard number Enter the keyword linecard followed by the line card slot number to clear BTM
error counters or status registers on the specified line card.
Range: 0 to 13 on a E1200, 0 to 6 on a E600/E600i, and 0 to 5 on an E300