Command Line Reference Guide

E-Series Debugging and Diagnostics | 1467
• show chassis
• show clock
• show environment
• show file-system
• show interface
• show inventory
• show ip management-route
• show ip protocols
• show ip route summary
• show processes cpu
• show processes memory
• show redundancy
•show rpm
• show running-conf
• show sfm
• show version
Without the page option, the command output is continuous, use CNTL-z to interrupt the command
output.
Example FTOS#show tech-support
------------------------------ show version -------------------------------
Dell Force10 Networks Real Time Operating System Software
System image file is "flash://FTOS-EF-6.5.4.1.bin"
Chassis Type: E600
Control Processor: IBM PowerPC 750FX (Rev D2.2) with 536870912 bytes of memory.
Route Processor 1: IBM PowerPC 750FX (Rev D2.2) with 1073741824 bytes of memory.
Route Processor 2: IBM PowerPC 750FX (Rev D2.2) with 1073741824 bytes of memory.
128K bytes of non-volatile configuration memory.
1 Route Processor Module
9 Switch Fabric Module
1 48-port GE line card with SFP optics (EF)
1 4-port 10GE LAN/WAN PHY line card with XFP optics (EF)
1 48-port 10/100/1000Base-T line card with RJ-45 interfaces (EF)
1 FastEthernet/IEEE 802.3 interface(s)
96 GigabitEthernet/IEEE 802.3 interface(s)
4 Ten GigabitEthernet/IEEE 802.3 interface(s)
-------------------------------- show clock -------------------------------
18:23:19.799 UTC Fri Mar 16 2007
--------------------------------- show HA information ----------------------
-- RPM Status --
------------------------------------------------
RPM Slot ID: 0
RPM Redundancy Role: Primary
RPM State: Active
RPM SW Version: 7.4.1.1
Link to Peer: Down
Peer RPM: not present
-- RPM Redundancy Configuration --
------------------------------------------------
Primary RPM: rpm0
Auto Data Sync: Full
Failover Type: Hot Failover
Auto reboot RPM: Disabled
Auto failover limit: 3 times in 60 minutes