Command Line Reference Guide

E-Series Debugging and Diagnostics | 1463
SkFull-Dr - Any IPC packet dropped because of socket full condition
Source-> Destination SeqNo HiWtmk(%) M-SkSize NonG-Rcvd Pri-Dr
SkFull-Dr
TME: 0 -> TME: 3 0 0 41600 1 0 0
TME: 3 -> LCMGR: 0 0 0 41600 1 0 0
IPC: 0 -> IPC: 3 37557 0 41600 6376 0 0
IPC: 3 -> TME: 3 16215 0 41600 0 0 0
CLI: 0 -> SYSADMTSK: 3 11483 0 41600 0 0 0
FTOS#
Example (show
processes ipc
send-stats)
FTOS#show processes ipc send-stats
IPC Send Statistics on CP
Memory Used by Send DB on this processor: 2303000 bytes
SeqNo - Last sent guaranteed IPC pkt sequence no from this source to destination
Success - No of successfull guaranteed IPC packets sent from source to destination
1st-R - No of first retry attempts
2nd-R - No of second retry attempts
Fails - No of guaranteed IPC pkts that could not be transmitted
RTT(ms) - Avg. Round Trip time for guaranteed IPC packets in millisecs
NonG-S - No of non-guaranteed IPC pkts succesfully sent. This does not
include those sent by SWP
NonG-F - No of non-guaranteed IPC pkt transmission failures
SWP-S - No of non-guaranteed SWP IPC pkts succesfully sent
SWP-F - No of non-guaranteed SWP IPC pkt transmission failures
Source-> Destination SeqNo Success 1st-R 2nd-R Fails RTT(ms)
NonG-S NonG-F SWP-S SWP-F
TME: 0 -> TME: 1 15868 1 0 0 0 1
0 0 0 0
FTOS#
Usage
Information
These commands should be used only when you are working directly with Dell Force10 TAC
(Technical Assistance Center) while troubleshooting a problem.
show processes ipc flow-control
e
Display the Single Window Protocol Queue (swpq) statistics.
Syntax
show processes ipc flow-control [cp | rp1 | rp2 | lp linecard-number]
Parameters
Defaults
No default values or behavior.
Command Modes
EXEC
EXEC Privilege
cp
(OPTIONAL) Enter the keyword cp to view the Control Processor’s swpq statistics.
rp1 (OPTIONAL) Enter the keyword rp1 to view the Control Processor’s swpq statistics
on Route Processor 1.
rp2 (OPTIONAL) Enter the keyword rp2 to view the Control Processor’s swpq statistics
on Route Processor 2.
lp linecard-number (OPTIONAL) Enter the keyword lp followed by the line card number to view the
Control Processor’s swpq statistics on the specified line card.