Command Line Reference Guide

E-Series ExaScale Debugging and Diagnostics | 1443
show interfaces transceiver
e
x
Display the physical status and operational status of an installed transceiver. The output also displays
the transceiver’s serial number.
Syntax
show interfaces gigabitethernet slot/port transceiver
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
AutoNegotiation Remote
Partner’s Ability
Displays the control words advertised by the remote interface during negotiation.
Duplex is either half or full. Asym- and Sym Pause is the types of flow control
supported by the remote interface
AutoNegotiation Expansion
ParallelDetectionFault is the handshaking scheme in which the link partner continuously
transmit an “idle” data packet using the Fast Ethernet MLT-3 waveform. Equipment that
does not support auto-negotiation must be configured to exactly match the mode of
operation as the link partner or else no link can be established.
1000Base-T Control 1000Base-T requires auto-negotiation. The IEEE Ethernet standard does not support
setting a speed to 1000 Mbps with the speed command without auto-negotiation. E-Series
line cards support both full-duplex and half-duplex 1000BaseT.
Phy Specific Control Values are:
0 - Manual MDI
1 - Manual MDIX
2 - N/A
3 - Auto MDI/MDIX
Phy Specific Status Displays PHY-specific status information. Cable length represents a rough
estimate in meters:
0 - < 50 meters
1 - 50 - 80 meters
2 - 80 - 110 meters
3 - 110 - 140 meters
4 - 140 meters.
Link Status:
Up or Down
Speed:
Auto
1000MB
100MB
10MB
Table 65-161. Lines in show interfaces gigabitethernet Command Example
Line Description
gigabitethernet Enter the keyword gigabitethernet followed by the slot/port information.
Version 8.1.1.2 Introduced on E-Series ExaScale E600i
Version 8.1.1.0 Introduced on E-Series ExaScale E1200i