Command Line Reference Guide

ManualsBrandsDell ManualsserversDell Force10 E600i

1411

1416 | E-Series ExaScale Debugging and Diagnostics

www.dell.com | support.dell.com

frrpaProcessIfmNotif(): Default case. type = 69

frrpaProcessIfmNotif(): Default case. type = 70

frrpaProcessIfmNotif(): Default case. type = 5

frrpaProcessIfmNotif(): Default case. type = 11

frrpaProcessIfmNotif(): Default case. type = 5

frrpaProcessIfmNotif(): Default case. type = 11

FTOS#

reset sfm

Reset a specific SFM module (power-off and then power-on).

Syntax

reset sfm slot-number

Parameters

Defaults

No default values or behavior

Command Modes

EXEC

Command

History

Usage

Information

When an error is detected on an SFM module, this command is a manual recovery mechanism. Since

this command can be used with live traffic running, the switch fabric will not go down if the switch

fabric is in an UP state. When there is a full set of SFMs online in the chassis, resetting one SFM will

reduce the total bandwidth supported by the chassis and may affect data flow. A warning message is

issued at the command line and requires user confirmation to proceed.

Example 1

(error message)

FTOS#reset sfm 0

SFM0 is active. Resetting it might temporarily impact data traffic.

Proceed with reset [confirm yes/no]:yes

Feb 16 00:39:30: %RPM1-P:CP %TSM-5-SFM_DISCOVERY: Found SFM 0

FTOS#

This command does not permit resetting any SFM when the system has (max-1) SFM and switch fabric

is up).

Example 2 FTOS#reset sfm 1

% Error: SFM1 is active. Resetting it will impact data traffic.

FTOS#

Commands

slot-number

Enter the slot number of the SFM to reset.

Range: 0 to 7

Version 8.1.1.0 Introduced on E-Series ExaScale

Note: Resetting an SFM in a power-off state is not permitted. Use the command power-on sfm to bring

the SFM back to a power-on state.

power-off/on sfm Power on/off an SFM