Command Line Reference Guide

1414 | E-Series ExaScale Debugging and Diagnostics
www.dell.com | support.dell.com
Example 2
(power-off sfm
with switch fabric
down warning)
FTOS#power-off sfm 1
WARNING!! SFM1 is active. Powering it off it will cause Switch Fabric to go down!!
Proceed with power-off [confirm yes/no]:yes
Feb 16 00:03:19: %RPM1-P:CP %TSM-6-SFM_SWITCHFAB_STATE: Switch Fabric: DOWN
Feb 16 00:03:20: %RPM1-P:CP %CHMGR-0-MAJOR_SFM: Major alarm: Switch fabric down
FTOS#
Once the SFM is powered off, the SFM status indicates that the SFM has been powered off by the user.
Use the show sfm all command to display the status.
Example 3
(show sfm all)
FTOS#show sfm all
Switch Fabric State: down (Not enough working SFMs)
Switch Mode: SFM
-- Switch Fabric Modules --
Slot Status
---------------------------------------------------------------------------
0 power off (SFM powered off by user)
1 power off (SFM powered off by user)
2 power off (SFM powered off by user)
3 active
4 active
5 active
FTOS#
Related
Commands
show command-history
e
x
Display the trace command history log.
Syntax
show command-history line number
Parameters
Defaults
No default behaviors or values
Command Modes
EXEC
Command
History
Example FTOS#show command-history 15
[1/15 14:59:27]: CMD-(CLI):[enable]by default from console
[1/15 15:9:15]: CMD-(CLI):[show linecard all]by default from console
[1/15 15:9:28]: CMD-(CLI):[interface gigabitethernet 12/0]by default from console
[1/15 15:11:51]: CMD-(CLI):[show startup-config]by default from console
[1/15 15:24:24]: CMD-(TEL46):[enable]by admin from vty0 (peer RPM)
[1/15 15:24:39]: CMD-(TEL46):[show version]by admin from vty0 (peer RPM)
[1/15 15:25:23]: CMD-(TEL46):[show interfaces managementethernet 1]by admin
from vty0 (peer RPM)
show sfm Display the current SFM status.
line number
(OPTIONAL) Enter the number of the most recent command history lines (commands).
For example, if you want to view the most recent ten command, enter the number 10.
Version 8.1.1.2 Introduced on E-Series ExaScale E600i
Version 8.1.1.0 Introduced on E-Series ExaScale E1200i