Command Line Reference Guide

Virtual Router Redundancy Protocol (VRRP) | 1397
show vrrp
c e s
Display information on the IPv4 and IPv6 VRRP groups that are active. If no VRRP groups are active,
the FTOS returns the message:
No Active VRRP group.
Syntax
show vrrp [ipv6] [vrid] [vrf instance | interface] [brief]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Example 1
(show vrrp brief)
FTOS> show vrrp brief
Interface Grp Pri Pre State Master addr Virtual addr(s) Description
-----------------------------------------------------------------------------------------
Gi 10/37 1 100 Y Master 200.200.200.200 200.200.200.201
Gi 10/37 2 100 Y Master 200.200.200.200 200.200.200.202 200.200.200.203
Gi 10/37 3 100 Y Master 1.1.1.1 1.1.1.2
Gi 10/37 4 100 Y Master 200.200.200.200 200.200.200.206 200.200.200.207
Gi 10/37 254 254 Y Master 200.200.200.200 200.200.200.204 200.200.200.205
ipv6
(OPTIONAL) Enter the keyword ipv6 to display information on IPv6 VRRP groups.
vrid
(OPTIONAL) Enter a Virtual Router identifier to display information on only the specified
VRRP group. Range: 1 to 255.
vrf instance (OPTIONAL) Enter the keyword vrf and the name of a VRF instance to display information
only on VRRP groups in the specified VRF. If no VRF instance is entered, information on
VRRP groups in all VRFs is displayed.
interface
(OPTIONAL) Enter any of the following keywords and slot/port or number:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the
slot/port information.
• For a Port Channel interface, enter the keyword port-channel followed by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For SONET interfaces, enter the keyword sonet followed by the slot/port.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed
by the slot/port.
• For a VLAN interface, enter the keyword vlan followed by the VLAN ID. The VLAN
ID range is from 1 to 4094.
brief
(OPTIONAL) E-Series only: Enter the keyword brief to display summary information on
VRRP groups.
Version 8.4.1.0 Support was added for displaying the VRRP groups in a non-default VRF instance.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
Table 64-155. Command Example Description: show vrrp brief
Item Description
Interface Lists the interface type, slot and port on which the VRRP group is configured.
Grp Displays the VRRP group ID.