Command Line Reference Guide

Control and Monitoring | 139
Table 7-12. Descriptions of show rpm output
Field Description
Status Displays the RPM’s status.
Next Boot Displays whether the RPM is to be brought online at the next system reload.
Card Type Displays the RPM catalog number.
Hardware Rev Displays theE-Series chipset hardware revision level: 1.0 (non-Jumbo); 1.5
(Jumbo-enabled); 2.0 (or above is TeraScale).
Num Ports Displays the number of active ports.
Up Time Displays the number of hours and minutes since the RPM’s last reboot.
Last Restart States the reason for the last RPM reboot.
C-Series possible values:
• “normal power-cycle” (
reset power-cycle command)
• “reset by master” (peer RPM reset by master RPM)
• “over temperature shutdown”
• “power supply failed”
E-Series possible values:
• “normal power-cycle” (insufficient power, normal power cycle)
• “reset by user” (automatic failover, software reload of both RPMs, or master RPM
resetting peer)
• “force-failover” (
redundancy force-failover command)
FTOS Version Displays the operating software version.
Jumbo Capable Displays a Yes or No indicating if the RPM is capable of sending and receiving Jumbo
frames.
This field does not indicate if the chassis is in Jumbo mode; for that determination, use the
show chassis brief command.
CP Boot Flash Displays the two possible Boot Flash versions for the Control Processor. The [Booted]
keyword next to the version states which version was used at system boot.
RP1 Boot Flash Displays the two possible Boot Flash versions for the Routing Processor 1. The [Booted]
keyword next to the version states which version was used at system boot.
RP2 Boot Flash Displays the two possible Boot Flash versions for the Routing Processor 2. The [Booted]
keyword next to the version states which version was used at system boot.
CP Mem Size Displays the memory of the Control Processor.
RP1 Mem Size Displays the memory of the Routing Processor 1.
PR2 Mem Size Displays the memory of the Routing Processor 2.
Temperature Displays the temperature of the RPM.
Minor alarm status if temperature is over 65° C.
Power Status Lists the status of the power modules in the chassis.
Voltage Displays the power rails for the line card.
Serial Num Displays the line card serial number.
Part Num Displays the line card part number.
Vendor ID Displays an internal code, which specifies the manufacturing vendor.
Date Code Displays the line card’s manufacturing date.
Country Code Displays the country of origin.
01 = USA