Command Line Reference Guide

Virtual Routing and Forwarding (VRF) | 1385
cam-profile ipv4-vrf
e
(E-Series Exascale only) Set the VRF CAM profile for IPv4 only.
Syntax
cam-profile ipv4-vrf microcode ipv4-vrf
Command Modes
CONFIGURATION
Command
History
Example FTOS(conf)#cam-profile ipv4-vrf microcode ipv4-vrf
FTOS(conf)#do reload
-- Chassis CAM Profile --
CamSize : 18-Meg
: Current Settings : Next Boot
Profile Name : ipv4-vrf : ipv4-vrf
L2FIB : 32K entries : 32K entries
L2ACL : 3K entries : 3K entries
IPv4FIB : 160K entries : 160K entries
IPv4ACL : 2K entries : 2K entries
IPv4Flow : 12K entries : 12K entries
EgL2ACL : 1K entries : 1K entries
EgIPv4ACL : 12K entries : 12K entries
Reserved : 2K entries : 2K entries
IPv6FIB : 0 entries : 0 entries
IPv6ACL : 0 entries : 0 entries
IPv6Flow : 0 entries : 0 entries
EgIPv6ACL : 0 entries : 0 entries
MicroCode Name : Ipv4-Vrf : Ipv4-Vrf
-- Line card 1 - per Port Pipe --
CamSize : 18-Meg
: Current Settings : Next Boot
Profile Name : ipv4-vrf : ipv4-vrf
L2FIB : 32K entries : 32K entries
L2ACL : 3K entries : 3K entries
IPv4FIB : 160K entries : 160K entries
IPv4ACL : 2K entries : 2K entries
IPv4Flow : 12K entries : 12K entries
EgL2ACL : 1K entries : 1K entries
EgIPv4ACL : 12K entries : 12K entries
Reserved : 2K entries : 2K entries
IPv6FIB : 0 entries : 0 entries
IPv6ACL : 0 entries : 0 entries
IPv6Flow : 0 entries : 0 entries
EgIPv6ACL : 0 entries : 0 entries
MicroCode Name : Ipv4-Vrf : Ipv4-Vrf
FTOS(conf)#
Usage
Information
Reload the system after entering this command to activate this CAM profile.
Do not use this command in EXEC Privilege mode.
Related
Commands
Version 8.2.1.0 Introduced on the E-Series
cam-profile ipv4-v6-vrf
Set the VRF CAM Profile for IPv4 and IPv6.