Command Line Reference Guide

1376 | VLAN Stacking
www.dell.com | support.dell.com
Usage
Information
You must remove the members prior to disabling the Stackable VLAN feature.
To view the Stackable VLANs, use the show vlan command in the EXEC Privilege mode. Stackable
VLANs contain members, designated by the M in the Q column of the command output.
FTOS#show vlan
Codes: * - Default VLAN, G - GVRP VLANs
NUM Status Q Ports
* 1 Inactive
2 Active M Gi 13/13
M Gi 13/0-2
3 Active M Po1(Gi 13/14-15)
M Gi 13/18
M Gi 13/3
4 Active M Po1(Gi 13/14-15)
M Gi 13/18
M Gi 13/4
5 Active M Po1(Gi 13/14-15)
M Gi 13/18
M Gi 13/5
FTOS#
vlan-stack dot1p-mapping
c s
Map C-Tag dot1p values to a S-Tag dot1p value. C-Tag values may be separated by commas, and
dashed ranges are permitted. Dynamic Mode CoS overrides any Layer 2 QoS configuration in case of
conflicts.
Syntax
vlan-stack dot1p-mapping c-tag-dot1p
values sp-tag-dot1p value
Parameters
Defaults
None
Command Modes
INTERFACE
Command
History
c-tag-dot1p value
Enter the keyword followed by the customer dot1p value that will be mapped to a
service provider do1p value.
Range: 0-7
sp-tag-dot1p value
Enter the keyword followed by the service provider dot1p value.
Range: 0-7
Version 8.3.1.0 Introduced on C-Series and S-Series.