Command Line Reference Guide

Spanning Tree Protocol (STP) | 1349
Defaults
20 seconds
Command Modes
SPANNING TREE
Command
History
Related
Commands
protocol spanning-tree
c e s
Enter the SPANNING TREE mode to enable and configure the Spanning Tree group.
Syntax
protocol spanning-tree stp-id
To disable the Spanning Tree group, enter no protocol spanning-tree stp-id command.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Example FTOS(conf)#protocol spanning-tree 0
FTOS(config-stp)#
Usage
Information
STP is not enabled when you enter the SPANNING TREE mode. To enable STP globally on the
switch, enter no disable from the SPANNING TREE mode.
Related
Commands
show config
c e s
Display the current configuration for the mode. Only non-default values are displayed.
Syntax
show config
Command Modes
SPANNING TREE
Command
History
Version 7.7.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
forward-delay Change the wait time before STP transitions to the Forwarding state.
hello-time Change the time interval between BPDUs.
stp-id
Enter zero (0). FTOS supports one Spanning Tree group, group 0.
Version 7.7.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
disable
Disable Spanning Tree group 0. To enable Spanning Tree group 0, enter
no disable.
Version 7.7.1.0 Introduced on S-Series