Command Line Reference Guide

1338 | Storm Control
www.dell.com | support.dell.com
• Similarly, if unicast storm control is enabled on an interface or globally on ingress, and DSCP
marking for a DSCP value 2 is configured for the data traffic, the traffic will go to queue 2 instead
of queue 0.
show storm-control broadcast
c e s
Display the storm control broadcast configuration.
Syntax
show storm-control broadcast [interface]
Parameters
Defaults
No default behavior or values
Command Modes
EXEC
EXEC Privilege
Command
History
Example 1
(E-Series)
FTOS#show storm-control broadcast gigabitethernet 11/11
Broadcast storm control configuration
Interface Direction Percentage Wred Profile
--------------------------------------------------------------
Gi 11/11 Ingress 5.6
Gi 11/11 Egress 5.6 -
FTOS#
Example 2
(C-Series)
FTOS#show storm-control broadcast gigabitethernet 3/24
Broadcast storm control configuration
Interface Direction Packets/Second
-----------------------------------------------
Gi 3/24 Ingress 1000
FTOS#
Note: Bi-directional traffic (unknown unicast and broadcast), along with egress storm control, causes
the configured traffic rates to be split between the involved ports. The percentage of traffic that each port
receives after the split is not predictable. These ports can be in the same/different port pipes, or the same/
different line cards.
interface
(OPTIONAL) Enter one of the following interfaces to display the interface specific storm
control configuration.
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the
slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by
the slot/port information.
• For a SONET interface, enter the keyword sonet followed by the slot/port information.
• Fast Ethernet is not supported.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
Version 6.5.1.0 Introduced on E-Series