Command Line Reference Guide

S-Series Stacking Commands | 1335
stack-unit renumber
s
Change the stack member ID of any stack member or a stand-alone S-Series.
Syntax
stack-unit 0-7 renumber 0-7
Parameters
Defaults
none
Command Modes
EXEC Privilege
Command
History
Usage
Information
You can renumber any switch, including the management unit or a stand-alone unit.
You cannot renumber a unit to a number of an active member in the stack.
When executing this command on the master, the stack reloads. When the members are renumbered,
only that specific unit will reset and come up with the new unit number.
Example S50V_7.7#stack-unit 0 renumber 2
Renumbering master unit will reload the stack. Proceed to renumber [confirm yes/no]:
Related
Commands
0-7
The first instance of this value is the stack member unit identifier, from 0 to 7, of the switch that you
want add to the stack.
The second instance of this value is the desired new unit identifier number.
Version 7.7.1.0 Introduced on S-Series
reload Reboot FTOS.
reset stack-unit Reset the designated S-Series stack member.
show system (S-Series) Display the current status of all stack members or a specific member.