Command Line Reference Guide

1334 | S-Series Stacking Commands
www.dell.com | support.dell.com
stack-unit priority
s
Configure the ability of an S-Series switch to become the management unit of a stack.
Syntax
stack-unit 0-7 priority 1-14
Parameters
Defaults
1
Command Modes
CONFIGURATION
Command
History
Related
Commands
stack-unit provision
s
Pre-configure a logical stacking ID of a switch that will join the stack. This is an optional command
that is executed on the management unit.
Syntax
stack-unit 0-7 provision {S25N|S25P|S25V|S50N|S50V}
Parameters
Defaults
When this value is not set, a switch joining the stack is given the next available sequential stack
member
identifier.
Command Modes
CONFIGURATION
Command
History
Related
Commands
0-7
Enter the stack member unit identifier, from 0 to 7, of the switch on which you want to set the
management priority.
1-14
This preference parameter allows you to specify the management priority of one backup switch over
another, with 0 the lowest priority and 14 the highest.
The switch with the highest priority value will be chosen to become the management unit if the
active management unit fails or on the next reload.
Version 7.7.1.0 Introduced on S-Series
reload Reboot FTOS.
show system (S-Series) Display the current status of all stack members or a specific member.
0-7
Enter a stack member identifier, from 0 to 7, of the switch that you want to add to the stack.
S25N|S25P|S25V||
S50N|S50V
Enter the S-Series model identifier of the switch to be added as a stack member. This
identifier is also referred to as the provision type.
Version 7.7.1.0 Introduced on S-Series
reload Reboot FTOS.
show system (S-Series) Display the current status of all stack members or a specific member.