Command Line Reference Guide

SONET | 1327
Related
Commands
sonet-port-recover detection-interval
e
Recovery interval to automatically clear a condition that could cause a SONET port to hang, and stop
sending and receiving data.
Syntax
sonet-port-recover detection-interval interval
Parameters
Defaults
60 seconds
Command Modes
INTERFACE
Privilege Level
15 sys-hidden
Command
History
Usage
Information
When enabled, FTOS continuously polls status registers on SONET line cards. A port hang is declared
when backpressure is detected on the port, and the port is brought down and then back up to clear the
condition.
To keep a port in shutdown use the hardware monitor mac action-on-error port-shutdown command.
Input 0 IP packets... Displays the number of packets with IP headers, VLAN tagged headers and MPLS headers.
The number of packets may not add correctly because a VLAN tagged IP packet counts as
both a VLAN packet and an IP packet.
0 64-byte... Displays the size of packets and the number of those packets entering that interface.
This information is displayed over 2 lines.
Any PPP packet less than 64 bytes in length will be padded out to 64 bytes upon reception.
This padding will be counted by the ingress byte counter.
Received 0... Displays the type and number of error or other specific packets received.
This information is displayed over 3 lines.
Output 0... Displays the type and number of packets sent out the interface.
This information is displayed over 2 lines.
Time since... Displays the time since the last change in the configuration of this interface.
Table 57-147. Fields in the show interfaces sonet with PPP Encapsulation
Field Description
show interfaces switchport Displays Layer 2 information about the interfaces.
show ip interface Displays Layer 3 information about the interfaces.
interval Interval for SONET port recovery (in seconds(15-600)
Version 7.7.1.0 Introduced