Command Line Reference Guide

1276 |sFlow
www.dell.com | support.dell.com
sflow enable (Interface)
c e s
Enable sFlow on Interfaces.
Syntax
sflow enable
To disable sFlow, use the no sflow enable command.
Defaults
sFlow is disabled by default on all interfaces
Command Modes
INTERFACE
Command
History
Usage
Information
When sFlow is enable on an interface, flow sampling is done on any traffic going out of the interface.
Related
Commands
sflow extended-gateway enable
e
Enable packing information on an extended gateway.
Syntax
sflow extended-gateway [extended-router] [extended-switch] enable
To disable packing information, use the no sflow extended-gateway [extended-router]
[extended-switch] enable command.
Parameters
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
Usage
Information
The show sflow command displays the configured global extended information.
FTOS 7.8.1.0 and later enhances the sFlow implementation for real time traffic analysis on the
E-Series to provide extended gateway information in cases where the destination IP addresses are
learned by different routing protocols, and for cases where the destination is reachable over ECMP.
Version 8.2.1.0 Introduces on S-Series Stacking
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
Version 6.2.1.1 Introduced on E-Series
Note: Once a physical port is a member of a LAG, it will inherit the sFlow configuration from the LAG port.
sflow enable (Global) Turn sFlow on globally
extended-router Enter the keyword extended-router to collect extended router information.
extended-switch Enter the keyword extended-switch to collect extended switch information.
enable Enter the keyword enable to enable global extended information.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series