Command Line Reference Guide

1274 |sFlow
www.dell.com | support.dell.com
Commands
The sFlow commands are:
• sflow collector
• sflow enable (Global)
• sflow enable (Interface)
• sflow extended-gateway enable
• sflow extended-router enable
• sflow extended-switch enable
• sflow polling-interval (Global)
• sflow polling-interval (Interface)
• sflow sample-rate (Global)
• sflow sample-rate (Interface)
• show sflow
• show sflow linecard
sflow collector
c e s
Configure a collector device to which sFlow datagrams are forwarded.
Syntax
sflow collector {ipv4-address | ipv6-address} agent-addr {ipv4-address | ipv6-address}
[number [max-datagram-size number]] | [max-datagram-size number]
Parameters
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
sflow collector ipv4-address
| ipv6-address
Enter the IPv4 (A.B.C.D) or IPv6 address (X:X:X:X::X) of the sFlow
collector device.
agent-addr ipv4-address |
ipv6-address
Enter the IPv4 (A.B.C.D) or IPv6 address (X:X:X:X::X) of the sFlow agent
in the router.
number
(OPTIONAL) Enter the udp port number (User Datagram Protocol).
Range: 0 to 65535
Default: 6343
max-datagram-size number
(OPTIONAL) Enter the keyword max-datagram-size followed by the
size number in bytes.
Range: 400 to 1500
Default: 1400
Version 8.4.1.1 On E-series ExaScale, support for IPv6 sFlow collectors and agents was added.
Version 8.2.1.0 Introduces on S-Series Stacking
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
Version 6.5.1.0 Expanded the no form of the command to mirror the syntax used to configure
Version 6.2.1.1 Introduced on E-Series