Command Line Reference Guide

Security | 1257
ip trace-list
e
Configure a trace list, based on IP addresses or protocols, to filter all traffic on the E-Series.
Syntax
ip trace-list trace-list-name
To delete a trace list, use the no ip trace-list trace-list-name command.
Parameters
Defaults
Not configured
Example FTOS(conf)#ip trace-list suzanne
FTOS(config-trace-acl)#
Command Modes
CONFIGURATION
Usage
Information
After you create a trace list, you must apply it to the E-Series using the ip trace-group command in the
CONFIGURATION mode.
Related
Commands
permit
e
Configure a filter to pass IP packets meeting the filter criteria.
Syntax
permit {ip | ip-protocol-number} {source mask | any | host ip-address} {destination mask | any
| host ip-address} [count [byte]| log]
To remove this filter, you have two choices:
•Use the no seq sequence-number command syntax if you know the filter’s sequence number or
•Use the no deny {ip | ip-protocol-number} {source mask | any | host ip-address}
{destination mask | any | host ip-address} command.
Parameters
Defaults
Not configured.
Command Modes
TRACE LIST
Related
Commands
trace-list-name
Enter a string up to 16 characters long as the access list name.
ip trace-group
View the current configuration.
ip Enter the keyword ip to configure a generic IP access list. The keyword ip
specifies that the access list will permit all IP protocols.
ip-protocol-number
Enter a number from 0 to 255 to permit based on the protocol identified in the IP
protocol header.
source
Enter the IP address of the network or host from which the packets were sent.
mask
(OPTIONAL) Enter a network mask in /prefix format (/x).
any Enter the keyword any to specify that all routes are subject to the filter.
host ip-address Enter the keyword host followed by the IP address to specify a host IP address.
destination
Enter the IP address of the network or host to which the packets are sent.
count (OPTIONAL) Enter the keyword count to count packets processed by the filter.
byte (OPTIONAL) Enter the keyword byte to count only bytes processed by the filter.
log (OPTIONAL) Enter the keyword log to have the information kept in a Trace-list log file.
ip trace-list
Create a trace list.
permit tcp
Assign a trace list filter to forward TCP packets.
permit udp
Assign a trace list filter to forward UDP packets.