Command Line Reference Guide

1256 | Security
www.dell.com | support.dell.com
Parameters
Defaults
Not configured.
Command Modes
TRACE LIST
Related
Commands
ip trace-group
e
Assign a trace list globally to process all incoming packets to the switch.
Syntax
ip trace-group trace-list-name
To delete an trace list configuration, use the no ip trace-group trace-list-name command.
Parameters
Defaults
Not enabled.
Command Modes
CONFIGURATION
Usage
Information
You can assign one Trace list to the chassis.
If there are unresolved next-hops and a Trace-list is enabled, there is a possibility that the traffic hitting
the CPU will not be rate-limited.
Related
Commands
source
Enter the IP address of the network or host from which the packets were sent.
mask
(OPTIONAL) Enter a network mask in /prefix format (/x).
any Enter the keyword any to specify that all routes are subject to the filter.
host ip-address Enter the keyword host followed by the IP address to specify a host IP address.
operator
(OPTIONAL) Enter one of the following logical operand:
• eq = equal to
•
neq = not equal to
• gt = greater than
•
lt = less than
•
range = inclusive range of ports
port port
(OPTIONAL) Enter the application layer port number. Enter two port numbers if
using the
range logical operand.
Range: 0 to 65535
destination
Enter the IP address of the network or host to which the packets are sent.
mask
(OPTIONAL) Enter a network mask in /prefix format (/x).
count (OPTIONAL) Enter the keyword count to count packets processed by the filter.
byte (OPTIONAL) Enter the keyword byte to count only bytes
log (OPTIONAL) Enter the keyword log to have the information kept in a Trace-list log file.
order number
(OPTIONAL) Enter the keyword order followed by a number from 0 to 7 as the order number.
deny Assign a trace list filter to deny IP traffic.
deny tcp Assign a trace list filter to deny TCP traffic.
trace-list-name
Enter the name of a configured trace list.
ip trace-list Configure a trace list ACL.