Command Line Reference Guide

Security | 1227
Defaults
Not configured.
Command Mode
CONFIGURATION
Command
History
radius-server deadtime
c e s
Configure a time interval during which non-responsive RADIUS servers to authentication requests are
skipped.
Syntax
radius-server deadtime seconds
To disable this function or return to the default value, enter no radius-server deadtime.
Parameters
Defaults
0 seconds
Command Modes
CONFIGURATION
Command
History
radius-server host
c e s
Configure a RADIUS server host.
Syntax
radius-server host {hostname | ipv4-address | ipv6-address} [auth-port port-number]
[retransmit retries] [timeout seconds] [key [encryption-type] key]
Parameters
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.2.1.1 Introduced on E-Series
seconds
Enter a number of seconds during which non-responsive RADIUS servers are skipped.
Range: 0 to 2147483647 seconds.
Default: 0 seconds.
Version 7.6.1.0 Introduced for S-Series
Version 7.5.1.0 Introduced for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
hostname
Enter the name of the RADIUS server host.
ipv4-address | ipv6-address
Enter the IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X), of the
RADIUS server host.
auth-port port-number (OPTIONAL) Enter the keyword auth-port followed by a number as the port number.
Range: zero (0) to 65535
The default
port-number is 1812.
retransmit retries (OPTIONAL) Enter the keyword retransmit followed by a number as
the number of attempts. This parameter overwrites the radius-server
retransmit command.
Range: zero (0) to 100
Default: 3 attempts