Command Line Reference Guide

Router Information Protocol (RIP) | 1181
show config
c e s
Display the changes you made to the RIP configuration. Default values are not shown.
Syntax
show config
Command Modes
ROUTER RIP
Command
History
Example FTOS(conf-router_rip)#show config
!
router rip
network 172.31.0.0
passive-interface GigabitEthernet 0/1
FTOS(conf-router_rip)#
show ip rip database
c e s
Display the routes learned by RIP. If the switch learned no RIP routes, no output is generated.
Syntax
show ip rip database [ip-address mask]
Parameters
Command Modes
EXEC Privilege
Command
History
Example FTOS#show ip rip database
Total number of routes in RIP database: 1624
204.250.54.0/24
[50/1] via 192.14.1.3, 00:00:12, GigabitEthernet 9/15
204.250.54.0/24 auto-summary
203.250.49.0/24
[50/1] via 192.13.1.3, 00:00:12, GigabitEthernet 9/14
203.250.49.0/24 auto-summary
210.250.40.0/24
[50/2] via 1.1.18.2, 00:00:14, Vlan 18
[50/2] via 1.1.130.2, 00:00:12, Port-channel 30
210.250.40.0/24 auto-summary
207.250.53.0/24
[50/2] via 1.1.120.2, 00:00:55, Port-channel 20
[50/2] via 1.1.130.2, 00:00:12, Port-channel 30
[50/2] via 1.1.10.2, 00:00:18, Vlan 10
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
ip-address
(OPTIONAL) Specify an IP address in dotted decimal format to view RIP information on
that network only.
If you enter an IP address, you must also enter a mask for that IP address.
mask
(OPTIONAL) Specify a mask, in /network format, for the IP address.
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series