Command Line Reference Guide

1176 | Router Information Protocol (RIP)
www.dell.com | support.dell.com
neighbor
c e s
Define a neighbor router with which to exchange RIP information.
Syntax
neighbor ip-address
To delete a neighbor setting, use the no neighbor ip-address command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER RIP
Command
History
Usage
Information
When a neighbor router is identified, unicast data exchanges occur. Multiple neighbor routers are
possible.
Use the passive-interface command in conjunction with the neighbor command to ensure that only
specific interfaces are receiving and sending data.
Related
Commands
network
c e s
Enable RIP for a specified network. Use this command to enable RIP on all networks connected to the
switch.
Syntax
network ip-address
To disable RIP for a network, use the no network ip-address command.
Parameter
Defaults
No RIP network is configured.
Command Modes
ROUTER RIP
Command
History
Usage
Information
You can enable an unlimited number of RIP networks.
RIP operates over interfaces configured with any address specified by the network command.
ip-address
Enter the IP address, in dotted decimal format, of a router with which to exchange information.
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
passive-interface Sets the interface to only listen to RIP broadcasts.
ip-address
Specify an IP network address in dotted decimal format. You cannot specify a subnet.
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series