Command Line Reference Guide

1174 | Router Information Protocol (RIP)
www.dell.com | support.dell.com
ip rip receive version
c e s
Set the interface to receive specific versions of RIP. The RIP version you set on the interface overrides
the version command in the ROUTER RIP mode.
Syntax
ip rip receive version [1] [2]
To return to the default, enter no ip rip receive version.
Parameters
Defaults
RIPv1 and RIPv2.
Command Modes
INTERFACE
Command
History
Usage
Information
If you want the interface to receive both versions of RIP, enter ip rip receive version 1 2.
Related
Commands
ip rip send version
c e s
Set the interface to send a specific version of RIP. The version you set on the interface overrides the
version command in the ROUTER RIP mode.
Syntax
ip rip send version [1] [2]
To return to the default value, enter no ip rip send version.
Parameters
Defaults
RIPv1.
Command Modes
INTERFACE
Command
History
Usage
Information
To enable the interface to send both version of RIP packets, enter ip rip send version 1 2.
Related
Commands
1 (OPTIONAL) Enter the number 1 for RIP version 1.
2 (OPTIONAL) Enter the number 2 for RIP version 2.
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
ip rip send version Sets the RIP version to be used for sending RIP traffic on an interface.
version Sets the RIP version to be used for the switch software.
1 (OPTIONAL) Enter the number 1 for RIP version 1.
The default is RIPv1.
2 (OPTIONAL) Enter the number 2 for RIP version 2.
Version 7.8.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
ip rip receive version Sets the RIP version for the interface to receive traffic.
version Sets the RIP version to be used for the switch software.