Command Line Reference Guide

Router Information Protocol (RIP) | 1167
50
Router Information Protocol (RIP)
Overview
Router Information Protocol (RIP) is a Distance Vector routing protocol. FTOS supports both RIP
version 1 (RIPv1) and RIP version 2 (RIPv2) on C-Series and E-Series and S-Series systems, as
indicated by the characters that appear below each command heading:
•C-Series:
c
•E-Series: e
•S-Series: s
The FTOS implementation of RIP is based on IETF RFCs 2453 and RFC 1058. For more information
on configuring RIP, refer to FTOS Configuration Guide.
Commands
The following commands enable you to configure RIP:
• auto-summary
• clear ip rip
• debug ip rip
• default-information originate
• default-metric
• description
• distance
• distribute-list in
• distribute-list out
• ip poison-reverse
• ip rip receive version
• ip rip send version
• ip split-horizon
• maximum-paths
• neighbor
• network
• offset-list
• output-delay
• passive-interface
• redistribute
• redistribute isis
• redistribute ospf
Note: The C-Series platform supports RIP with FTOS version 7.6.1.0 and later. The S-Series platform
supports RIP with FTOS version 7.8.1.0 and later. Prior to 7.6.1.0, only the E-Series platform
supported RIP.