Command Line Reference Guide

Quality of Service (QoS) | 1157
Queue-Level Debugging
Queue-Level Debugging is an E-Series-only feature,, as indicated by the e character that appears
below each command heading.
The following queuing statistics are available on TeraScale versions of E-Series systems.
• clear queue statistics egress
• clear queue statistics ingress
• show queue statistics egress
• show queue statistics ingress
clear queue statistics egress
e
Clear egress queue statistics.
Syntax
clear queue statistics egress [unicast | multicast] [Interface]
Parameters
Defaults
No default behavior or values
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
If a Policy QoS is applied on an interface when clear queue statistics egress is issued, it will clear the
egress counters in show queue statistics and vice-versa. This behavior is due to the values being read
from the same hardware registers.
Related
Commands
unicast | multicast (OPTIONAL) Enter the keyword multicast to clear only Multicast queue statistics.
Enter the keyword
unicast to clear only Unicast queue statistics.
Default: Both Unicast and Multicast queue statistics are cleared.
Interface
(OPTIONAL) Enter one of the following interfaces to display the interface specific
queue statistics.
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed
by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port information.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
•Fast Ethernet is not supported
Version 6.2.1.1 Introduced
clear queue statistics egress
Clear ingress queue statistics
show queue statistics egress
Display egress queue statistics
show queue statistics ingress
Display ingress queue statistics